Related Manuals for DeWalt D28108-XE
Summary of Contents for DeWalt D28108-XE
- Page 1 INSTRUCTION MANUAL ANGLE GRINDER MODEL: D28108-XE, D28127-XE, D28128-XE, D28154-XE...
-
Page 2: Side Handle
SAFETY INSTRUCTIONS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and personal injury. Read the following safety instructions before attempting to operate this product. Keep these instructions in a safe place. - Page 3 • Check that the workpiece is properly supported. Do not use the tool if switch is defective. Have the switch replaced by an authorised DeWALT • Do not operate the tool near flammable liquids, gases or dust. Sparks or hot chips from cutting Repair Centre.
- Page 4 MOUNTING SIDE HANDLE (Fig. 1) FITTING AND REMOVING GUARD (Fig.2a). (D28108-XE) Fig. 1 Fig. 2a 17 17 Place the angle grinder on a table, spindle up. Align the lug on the guard with the slot in the • Screw the side handle (5) tightly into one of the holes (17) on either side of the plate.
- Page 5 OPERATION • Press the spindle lock (3) and rotate the spindle (11) until it locks in position. Switch • Tighten the flange (14) with the two-pin spanner (Fig.3) (15) supplied. • Release the spindle lock. Fig. 5 1 • To remove the disc, loosen the flange (14) with the two-pin spanner (Fig.3)(15) Do not use a damaged disc.
-
Page 6: Personal Safety
Personal Safety IMPORTANT: When using the tool for sanding, allow only a segment of the disc to contact the work and refrain from high-pressure application.(Fig. 6). No children or pregnant women should enter the work area where paint sanding is being Fig. -
Page 7: Maintenance
All DeWALT power tools are thoroughly tested before leaving the factory. However, if the power tool needs repair, please contact your dealer or take it to your nearest DeWALT Service Centre. There is Blowing dust and grit out of the motor housing using compressed air is a necessary regular a Service Centre in every capital city. - Page 8 If you are dissatisfied with any DeWALT power tool , for any reason, simply return it to the point of purchase with your sales receipt within 30 days for a replacement unit or a full refund.
- Page 9 Note: This instruction manual is applicable for the following subcodes: –XE WALT Industrial Tool Company Part No. 615269-00 Industrial Tool Company Part No.