Maintenance; Precautions; Daily Inspection Prior To Operation; Maintenance And Inspection List - SCANMASKIN Scan Combiflex 800 User Manual

Scan Combiflex 800 – Manual
Chapter 3

5 Maintenance

5.1 Precautions

Set the machine into the Safety off position before beginning any work on the machine.
See "2.7Definition of the "Safety off position"".
Read "2.6Electrical safety" before beginning any maintenance work.
Never work on the machine while power is still connected!
All parts must have come to a complete stop before beginning any work!
When the machine is lying down on its back it might tilt to it's upwards position. Take extra
care to prevent this from happening to ensure that no injuries or damages occur.
When the machine has been operated the segments, Scan-On plates and other parts on the
gear barrel may be hot. Take extra care to prevent burn injuries.
Adjustment, servicing and inspection work on the period of time limits, specified in this User
Guide as well as any information on the replacement or parts and equipment must be undertaken
and/or complied with!
These activities may only be undertaken by qualified personnel.
The machine must not be connected to any power source while cleaning.

5.2 Daily inspection prior to operation

Inspect the following items prior to operation
 Inspect the wheels for damage.
 Inspect the grinding heads. Dirt between the Scan-On plate and the grinding hub can
impair the flexibility of the grinding head.
 If any screws appears loose, tighten them.
 Look over the machine for any other damage.

5.3 Maintenance and inspection list

Daily
12 hours after service

5.4 Grinding disc replacement / assembly

Follow these steps to replace the Scan-On plate
 Inspect the wheels
 Inspect the grinding heads
 Look for any other damage
 Tighten all screws
- 19 -