Installation Of Indoor Unit - Daikin FTXV25AV1B Owner's Manual

Installation of indoor unit

Step one: choosing installation location
Recommend the installation location to the client and then confirm it with the client.
Step two: install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
level meter and then point out the screws fixing holes on the wall.
2. Drill the screw fixing holes on the wall with impact drill (the specification of drill
head should be the same as the plastic expansion particle) and then fill the plastic
expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
then check if the frame is firmly installed by pulling the frame. If the plastic
expansion particle is loose, please drill another fixing hole nearby.
Step three: open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe.
The position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
50 class:
Wall
Mark in the middle of it
Space
to the
wall
above
150mm
Left
ø55mm
(Rear piping hole)
2. Open a piping hole with the diameter of Ø55 or Ø70 on the selected outlet pipe
position. In order to drain smoothly, slant the piping hole on the wall slightly
downward to the outdoor side with the gradient of 5-10°.
25 and 35 class:
Wall
Mark in the middle of it
Space
to the
wall
above
150mm
Left
ø55mm
(Rear piping hole)
Wall
Level meter
Space
to the
wall
above
150mm
Right
ø55mm
(Rear piping hole)
Level meter
Space
to the
wall
above
150mm
Right
ø55mm
(Rear piping hole)
Wall
Mark in the middle of it
Space
to the
wall
above
150mm
Left
ø70mm
(Rear piping hole)
7
Wall
60 class:
Level meter
(Rear piping hole)
Wall
Space
to the
wall
above
150mm
Right
ø70mm