Advertisement
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard
and trims using soapy water. Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see below for how to remove the
radiants.
See figure 4.
Always use the
correct type of
replacement radiant.
Ask for part number
0544649 (GC No. 125
164).
Turn the fire off
and allow it to cool
before attempting to
remove the radiants.
Remove the dress
guard by pressing
down the two hooks at
the top. Tilt the guard
forward and lift out.
Lift the radiant
upward to clear the
metal retaining bar
then pull out bottom
first.
Fit the new
radiant by inserting its
top under the top lip of
the radiant box then
swing the bottom of
the radiant over and behind the retaining bar. It is important that the back face of the
radiant should rest against the rear ribs in the firebox. There will be a small gap
between the bottom front edge of the radiant and the retaining bar.
OWNER GUIDE
CLEANING
REPLACING THE RADIANTS
Figure 4. Replacing radiant
Page 9
Hide quick links:
Advertisement
