Quadra-Fire VOYA-GRAND-MBK Owner's Manual page 42

. r urr u
Standard Si e: 42-1/2 in. W
Large Si e: 4 in. W
u e i urr u i
u e i ri i
fastener package.
ee e Powered 4 to 6 inches long Phillips head
1. Remove contents from bo being careful not to scratch or
damage the cast trim pieces.
. Lay surround face down on a protected surface to prevent
2
scratching.
3. sing a 4 to 6 inches long Phillips head screw driver attach
metal screws on each side provided with the kit
4
. Place the peel and stick round felt vibration insulation pads
on the front side in each corner of the top metal piece and
on the back side in each corner of the top cast piece. Figure
2. .
on the top cast piece and 2 bosses on each side piece.
6. Secure the magnet to the bracket and attach the magnet and
bracket to each metal side piece at the bottom.
is facing the front. Figure 2.2.
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Figure 2.
Page 42
er
ri i
30 in.
34 in.
he magnet
Cast Footers,
Left & Right
7. Place the cast footers under the metal sides aligning the top
and bottom holes in the cast footers and metal sides.
. he mounting clips are shipped in one long strip.
break apart or use pliers.
. ach clip has a clearance notch to allow room for the cast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds. Figure 2.3.
10. t is best to install all of the 1/4-20 screws only half way at
around to the rest.
11. Slide surround and trim over the top of the insert into place
matching the mounting tabs on the metal sides with the slots
on the insert. Figure 2. .
12
2 alignment holes on the appliance top. Secure in place.
Figure 2. .
Back
of
Side
Piece
Magnet Attached - Faces Front
Figure 2.2
Match Mounting
Tabs to Slots on
the appliance
Figure 2.
7075-166C
R
and
Clearance Notch
Figure 2.3
May 23, 2013