Quadra-Fire VOYA-GRAND-MBK Owner's Manual page 21

R
er e rts Re
A G ss Re e ent
(Replace with 5mm ceramic glass only)
1.
the touch.
2. Protect a table or counter top with padding or towels.
3. Remove the door with the broken glass by lifting the
door up and off of the hinges.
4. Lay door face down on a table or counter making sure
a soft surface.
5. Remove the screws from each glass retainer and remove
6. Center the glass with edges evenly overlapping the
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8.
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately, a
few turns at a time, until the glass is secure. DO NOT
O ERTIGHTEN - can cause glass to break.
9. Replace the door on the appliance.
WARNING! Risk of Fire or Injury!
CAUTION!
Quadra-Fire appliances are equipped with ceramic super
heat-resistant glass, which can only be broken by impact or
misuse.
n D s Re
1. The grille on the blower access assembly is hinged. Swing
the grille downward to expose the 2 screws.
on e
May 23, 2013
e ent
UN UG A I E RO
E ORE RE A ING ANY O
e ent
re
VOYAGEUR GRAND Wood Insert
ANY OWER OUR E
ONEN
n D s Re
2. Remove the 2 screws from the blower access assembly
and slide assembly away from the appliance
3. Locate the snap disc bracket assembly behind the blower
controls on the right side under the ash lip.
4. Remove the 2 mounting screws in the blower control
bracket and slide assembly towards you.
5. sing a Phillips head screw driver, remove the 2 screws
from the snap disc and lift the snap disc off of the mounting
bracket. Disconect the wires and replace with new snap
disc and re-connect the wires.
6. Slide the blower control bracket back into position and
secure with the 2 mounting screws.
re
W r n D
Black
Snap Disc
Black
Switch
re
7075-166C
e ent ont d
Blower Controls & Snap
Disc Under Ash Lip
Snap Disc
n D s o t on
r
Blower
White
White
Black
White
Rheostat
re
Power Cord
Page 21