Accessories Supplied With The Unit; Installation Site Selection; Mounting Of The Unit - Technibel REVE 247C Operating Instructions Manual

ACCESSORIES SUPPLIED WITH THE UNIT

1. PLASTIC TUBE (1pcs.)
2. EXTERNAL GRILLES (2pcs.)
3. INTERNAL GRILLES (2pcs.)
4. TENSION BARS (2pcs.)
5. FULL SCALE DIAGRAM (1pcs.)
EG
6. RAWL PLUGS + SCREWS (15pcs.)
7. REMOTE CONTROL UNIT (1pcs.)
8. BATTERIES FOR REMOTE CONTROL (2pcs.)
INSTALLATION
The installation should be carried out by a qualified installer,
following the instructions as shown.

INSTALLATION SITE SELECTION

In case you should replace a radiator in an already existing
●
heating system, follow the instruction of the boiler
connection kit
The wall must be a perimeter one.
●
Fix the unit at a minimum height of 10 cm and a maximum
●
height of 100 cm.
Select a sufficiently strong location to support the weight
●
of the unit.
Allow access for maintenance operation around the unit.
●
Make sure that there are no obstacles around the unit
●
affecting the free circulation of air.
Avoid installing the unit with the air flow directly toward
●
passerby people, electric appliances or heat sources.
CAUTION
After the selection of the installation site, according to
the above mentioned points, be sure not to make holes
in areas where electrical wiring or conduits are located,
damaging them.
Make sure that there are no obstacles in the conduits
inside the wall affecting the free circulation of the
external air. The unit must be kept at a minimum
distance of 80 cm from any wall or obstacle.

MOUNTING OF THE UNIT

- Apply at the wall the full scale diagram, fix and level it.
- Drill the two holes Ø 162 mm and eventually the hole
Ø 35 mm in case of heat pump unit for the condensate
drainage toward the outside (assure a positive slope
toward the outside).
2
7
8
Level
3
1
6
3
Full scale
diagram
Mill
5
4