Install Heart Rate Belt (Optional) - Bryton Rider 100 User Manual

NOTE:
• To ensur e optimum performance, do the following:
- Align both sensor and magnet as shown in the illustration (5a / 5b). Pay attention on the
alignment points.
- Ensure the distance between the sensor and the magnet is within 3 mm.
• Ensure that both Speed sensor and Speed magnet are installed and aligned horizontally,
not vertically.
• On the initial usage, press the front button to activate the sensor and start pedaling.
When the sensor detects the magnet, the LED blinks once to indicate the alignment is

Install Heart Rate Belt (Optional)

1
4
NOTE:
• In cold weather, wear appropriate clothing to keep the heart rate belt warm.
• The belt should be worn directly on your body.
• Adjust the sensor position to the middle part of the body (wear it slightly below the
chest). The Bryton logo shown on the sensor should be facing upward. Tighten the elastic
• If the sensor cannot be detected or the reading is abnormal, please warm up for about 5
minutes.
• If the heart rate belt is not used for a period of time, remove the sensor from the heart
rate belt.
30 Appendix
Strap
2
Remove battery tab before use
Electrodes
5
3