IHP CAPELLA 33 Installation And Operation Instructions Manual

IHP CAPELLA 33 Installation And Operation Instructions Manual

Advertisement

INSTALLATION AND

OPERATION INSTRUCTIONS

33" ELECTRIC FIREPLACES
33" Electric Fireplaces
P/N 900274-00 Rev. NC 11/2015
MODELS
CAPELLA 33
ERT3033
This manual will enable you to obtain a safe, effi cient and dependable
installation and operation of your electric fi replace. Please read and
understand these instructions before beginning your installation.
Do not alter or modify this fi replace or its components under any circum-
stances. Any modifi cation or alteration of the fi replace system, including
but not limited to the fi replace and accessories, may void the warranty,
listings and approvals of this system and could result in an unsafe and
potentially dangerous installation.
IMPORTANT! IF OPTIONAL GLASS DOORS ARE PURCHASED, TO
ASSURE PROPER ALIGNMENT, INSTALL THIS FIREPLACE IN A
SQUARE AND PLUMB CONDITION, USING SHIMS AS NECESSARY
AT SIDES. THIS APPLIANCE IS MOUNTED ON RUBBER FEET TO
ENSURE ADEQUATE AIR CIRCULATION BENEATH FIREPLACE.
DO NOT BLOCK AIRFLOW AT THE BOTTOM AIR INTAKES.
INSTALLER: Leave this manual with the appliance
CONSUMER: Retain this manual for future reference
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE
VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER
APPLIANCE.
IHP electric fi replaces are designed for use as a decorative appli-
ance and/or as a supplemental heater. They are not intended
for continuous use as a primary heat source.
A French manual is available upon request. Order P/N 900277-00
Ce manuel d'installation est disponible en francais, simplement en
faire la demande. Numéro de la pièce 900277-00.
®
C
US
SPARK 33
MPE33-2
Report # C1482763

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CAPELLA 33 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for IHP CAPELLA 33

  • Page 1: Operation Instructions

    VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. IHP electric fi replaces are designed for use as a decorative appli- ance and/or as a supplemental heater. They are not intended for continuous use as a primary heat source.
  • Page 2: Important Safety Information

    UNDER NO CIRCUMSTANCES SHOULD IMPORTANT SAFETY AND IMPORTANT THIS FIREPLACE BE MODIFIED. PARTS WARNIING INFORMATION HAVING TO BE REMOVED FOR SERVICING These fi replaces are designed MUST BE REPLACED PRIOR TO OPERAT- as supplemental heaters. There- ING THE FIREPLACE AGAIN. READ THIS MANUAL IN ITS fore, it is advisable to have an ENTIRETY AND UNDERSTAND...
  • Page 3: Table Of Contents

    Power Supply Wire Gage Voltage Wire Gage Fuse In selecting this Innovative Hearth Products (IHP) electric fi replace, you have chosen the fi nest and most dependable fi replace found anywhere. A beautiful and prestigious 120 V 14 GA. 15 AMP addition to the fi...
  • Page 4: Framing Specifi Cations

    FRAMING SPECIFICATIONS 25-5/8 " (651 mm) 36-1/4 " (921 mm) 35-1/4 " (895 mm) 51-1/4 " (1302 mm) Electrical Junction Electrical 32 " Junction 35-1/4 " (812 mm) (895 mm) (left side) Corner View 4 " (102 mm) 15-1/8 " Front View Note: Framing dimensions are calculated for a nailing fl...
  • Page 5: Clearances

    PRE-INSTALLATION an Amp rating for the appropriate voltage (120 V - 15 Amps or 240 V - 20 Amps). Before You Start Model: CAPELLA 33 A dedicated circuit is required to prevent Check appliance for any concealed damage. Model: ERT3033...
  • Page 6: Final Finishing

    MANUAL CONTROL PANEL OPERATION FINAL FINISHING MANUAL CONTROL PANEL (refer to Figures 4 & 5) Materials such as brick and tile can be extended Main Power On/Off (rear most switch) Once this appliance has been properly installed down to the top of the fi replace. Do not extend and connected to the power supply as defi...
  • Page 7: Remote Control Operation

    Installed In Remote Control. Note: If the fl ame does not come on imme- diately, adjust brightness and intensity The IHP Electric Fireplace is provided (buttons E & K). with an Infrared light Remote Control. All functions of the fi replace can be con- trolled through the remote control.
  • Page 8: Maintenance

    MAINTENANCE b. Turn the power and heater switches on 3. Open the screens (remove glass panel enclosure, if applicable). and check for proper operation. This appliance has been designed to provide c. Turn off power to the fi replace. many years of trouble-free service. The com- 4.
  • Page 9: Warning

    Figure 16 • Replacement LED strips are available through iii. Locate fl ame cylinder drum (see Figure IHP (see page 16). 17). Locate the cotter pin on left side of 1. Turn off power to the fi replace. fl ame cylinder and remove it. Remove 2.
  • Page 10: Wiring Diagrams

    WIRING DIAGRAM - 120 VOLT Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on the left side. CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DAN- GEROUS APPLIANCE OPERATION.
  • Page 11: Warning

    WIRING DIAGRAM - 240 VOLT Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on the left side. CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DAN- GEROUS APPLIANCE OPERATION.
  • Page 12 WALL THERMOSTAT & WALL SWITCH WIRING DIAGRAMS (optional kits, see Page 18) OUTSIDE INSIDE POWER ON/OFF SWITCH POWER ON/OFF SWITCH (ON CONTROL PANEL) (OPTIONAL WALL SWITCH) GREEN GROUND • When using the manual control panel power on/off switch, the outside power on/off switch (optional wall switch kit) must be in the OFF position.
  • Page 13 Installing Wall Thermostat (optional kit, see Page 18) Wire the wall thermostat prior to installing the fi replace. WALL THERMOSTAT WIRING (24 VAC): Install Wall Thermostat per instructions provided with kit and per the following information: 1. Turn off circuit breaker. 2.
  • Page 14 Power On/Off Wall Switch Installation (optional kit, see Page 18) Wire the wall switch prior to installing the fi replace. WALL SWITCH WIRING (24 VAC): Install Wall Switch per instructions provided with kit and per the following information: 1. Turn off circuit breaker. 2.
  • Page 15: Troubleshooting

    TROUBLESHOOTING Symptom Possible Causes Who Performs Corrective Corrective Action Action 1. Fireplace turns off and will not Fireplace has overheated. Homeowner The appliance is protected with a safety turn on and an audible beeping device to prevent it from overheating. If noise can be heard.
  • Page 16: Replacement Parts

    REPLACEMENT PARTS - MODELS CAPELLA 33, SPARK 33, MPE33-2, AND ERT3033 ITEM DESCRIPTION 33" Electric Fireplaces CAT. NO. LED Light Strip Embers H9106 Side Frames, 1 Left And 1 Right H1942 Circuit Board LED 33 & 36 H9107 Nailing Flange Kit, (4 Each)
  • Page 17 REPLACEMENT PARTS COMPONENT DIAGRAMS - MODELS CAPELLA 33, SPARK 33, MPE33-2, AND ERT3033 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
  • Page 18: Optional Accessories

    H3433 GEP-33PB Glass Enclosure Panel, Brass on Bronze H3434 GEP-33BS Glass Enclosure Panel, Stainless on Bronze PRODUCT REFERENCE INFORMATION Please contact your IHP dealer for any questions or concerns. For the number of your nearest dealer, contact us at IHP.us.com. INNOVATIVE HEARTH PRODUCTS...
  • Page 19: Warranty Certifi Cate

    In order for any claim under this warranty to be valid, you must contact the IHP dealer/distributor from which you purchased the product. If you cannot locate the dealer/ distributor, then you must notify IHP in writing. IHP must be notifi ed of the claimed defect in writing within 90 days of the date of failure. Notices should be directed to the IHP Warranty Department at 1508 Elm Hill Pike, Suite 108;...
  • Page 20 IHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, and prices, and also to discontinue colors, styles, and products. Consult your local distributor for fi replace code information. Printed in U.S.A. © 2015 Innovative Hearth Products P/N 900274-00 Rev.

Table of Contents