Section B: Using Touchscreen Terminal; Chapter 3: Touch Screen Calibration (If Needed) - PIONEERPOS CYPRUS User Manual

Section B: Using Touchscreen Terminal

Chapter 3: Touch screen calibration (if needed)

[NOTE]
Following instructions are only applicable to RESISTIVE type touch panel. PCAT (projective capacitive) type touch panel
will NOT require calibration in either Windows 7 or Windows 8.1 operating environment. Atom DualCore model does not
support Windows 8.1 based operating environment.
3.1 Calibration on Windows 7 or POS Ready 7
Cyprus's Touch Screen can be operated with finger or soft stylus. If you have re-installed the driver software, you need to
open TouchKit to re-calibrate the touch screen:
1. Go to Start -> All Programs -> eGalaxTouch -> Configure Utility.
Click on "Tools" when you need to calibrate.
2.
3. Perform 4 point calibration when you see the calibration screen. Use a touch screen stylus pen or your finger to
touch each point for about 1-2 seconds until you hear a "beep" sound.
[Note] Linearization is not needed for regular use.
Manual for CYPRUS (V1.0) (Atom Dual Core) Page 11