Introduction; General; Symbols Used; Abbreviations - Heatrae Sadia Multipoint 10 and 15 litre Fitting Instructions Manual

1. Introduction

1.1 General

The following instructions are offered as a guide to
the user and installer.
The installation must be carried out by a competent
plumbing and electrical installer in accordance
with Building Regulation G3 (England and Wales),
Technical Standard P3 (Scotland) or Building
Regulation P5 (Northern Ireland) and the Water
Fitting Regulations (England and Wales) or Water
Byelaws (Scotland).

1.2 Symbols used

In these instructions, various risk levels are employed
to draw the user's attention to particular information.
In doing so we wish to safeguard the user, avoid
hazards and guarantee the correct operation of the
appliance.
DANGER
Risk of dangerous situation causing slight
physical injury.
WARNING
Risk of dangerous situation causing slight
physical injury.
CAUTION
Risk of material damage.

Signals important information.

1.3 Abbreviations

RCD – Residual current device
`
MCB – Miniature circuit breaker
`

1.4 Liabilities

Manufacturer's liability
Our products are manufactured in compliance with
the requirements of the various applicable European
Directives.
This product complies with the requirements of the
CE marking directive.
In the interest of UK customers, we are continuously
endeavouring to make improvements in product
quality. All the specifications stated in this document
are therefore subject to change without notice.
Our liability as the manufacturer may not be invoked
in the following cases:
Failure to abide by the instructions on using the
`
product.
Faulty or insufficient maintenance of the product.
`
Failure to abide by the instructions on installing
`
the product.
Installer's liability
The installer is responsible for the installation and
the commissioning of the product. The installer must
respect the following instructions:
Read and follow the instructions given in the
`
manuals provided with the product.
Carry out installation in compliance with the
`
prevailing legislation and standards.
Perform the initial start-up and carry out any
`
checks necessary.
Complete the commissioning checklist.
`
Explain the installation to the user.
`
If maintenance is necessary, warn the user of
`
the obligation to check the product and maintain
it in good working order.
Give the instruction manual to the user.
`
User's liability
To guarantee optimum operation of the product, the
user must respect the following instructions:
Read and follow the instructions given in the
`
manuals provided with the product.
Call on qualified professionals to carry out
`
installation and initial start-up.
Get your fitter to explain your installation to you.
`
Have your required checks and services done.
`
Keep the instruction manuals in good condition
`
and close to the product.
3