Carburetor Remove; Auto By-Starter - Sym DD 50 Service Manual

10. FUEL SYSTEM

Carburetor Remove

Remove the body cover.
Disconnect the auto by-starter connector.
Loosen draining screw and then drain out fuel
inside the carburetor.
Loosen carburetor upper part and remove
carburetor upper part.
Remove fuel and oil hoses from carburetor.
Remove carburetor mounting bolt and carburetor.

Auto By-Starter

Inspection
Connect resistor meter to the terminals of auto
by-starter, and then measure its resistance.
If the resistance value exceeds specification too
much, it means that the PTC in the auto
by-starter is malfunction. Then, replace the auto
by-starter.
Resistance value: Max. 10Ω(at cold engine)
Caution
If the resistance value exceeds the standard a
little bit, the auto by-starter may still in normal.
However, it is necessary to check other relative
components for damage.
10-4
This chapter Contents
Draining screw
Auto by-starter
Fuel hose
Bolt
Connection hose clamp
Carburetor
Auto by-starter
Carburetor
upper part