Related Manuals for Bartscher 104.025
Summary of Contents for Bartscher 104.025
- Page 1 104.025 / 104.040 Bedienungsanleitung Eiswürfelbereiter D/A/CH Seite 3 bis 15 Instruction manual Ice cube maker GB/UK from page 17 to 29 Mode d’emploi Machine à glaçons F/B/CH de page 31 à page 43 V3/0312 - 1 -...
-
Page 2: Table Of Contents
5.3 Operating 6. Cleaning and maintenance 6.1 Safety advice 6.2 Cleaning 6.3 Safety instructions for maintenance 7. Possible malfunctions 8. Waste disposal Bartscher GmbH Franz-Kleine-Str. 28 D-33154 Salzkotten phone: +49 (0) 5258 971-0 Germany fax: +49 (0) 5258 971-120 - 17 -... -
Page 3: General Information
1. General information 1.1 Information about the instruction manual This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. -
Page 4: Liability And Warrantees
1.3 Liability and Warrantees All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. However, we do not accept liability for any translation errors. -
Page 5: Safety
2. Safety This section provides an overview of all important safety aspects. In addition every chapter provides precise safety advice for the prevention of dangers which are highlighted by the use of the above mentioned symbols. Furthermore, attention should be paid to all pictograms, markers and labels on the device, which must be kept in a permanent state of legibility. -
Page 6: Intended Use
CAUTION! o The unit is not intended for use by individuals (including children) with physical or mental disabilities, insufficient experience, and/or insufficient knowledge unless such persons are under the care of a person responsible for their safety or have received instructions regarding appropriate use of the unit. -
Page 7: Delivery, Packaging And Storage
3. Transport, packaging and storage 3.1 Delivery check Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery. Trigger off the complaint. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. -
Page 8: Technical Data
4. Technical data 4.1 Technical specifications Description Ice cube maker 104.025 104.040 Item no.: C 25 C 40 Model: Cooling agent: R134a / 130 g R134a /200 g Connected load: 230 V ~ 50 Hz Power: 220 W 380 W approx. -
Page 9: Features
4.3 Features Air cooling Paddle system Electronically controlled compressor Light sensor controlled ice cube production With water supply and outlet 5. Installation and operation 5.1 Safety instructions WARNING! Electrical hazard! The device must only be connected to a properly installed single socket with protective contact. -
Page 10: Installation And Connection
WARNING! Hazard via electrical current! The device can cause injuries due to improper installation! Before installation the local power grid specification should be compared with that of the device (see type label). Connect the device only in case of compliance! Take note of the security advice! 5.2 Installation and connection ATTENTION! -
Page 11: Operating
• Attach one end of the drainage hose using the rubber drainage cuff at the rear of the unit. Attach the second end to a sewage outlet or water container. The sewage outlet or water container must be situated lower than the ice cube maker, so that water flows out. -
Page 12: Cleaning And Maintenance
6. Cleaning and maintenance 6.1 Safety advice o Before beginning with repair or cleaning works make sure the device has been disconnected from power socket (pull the power plug!!!) and has cooled down. o Do not use any acid agents and make sure no water ingresses the device. o To protect yourself from electric shock, never immerse the device, its cables and the plug in water or other liquids. -
Page 13: Possible Malfunctions
7. Possible Malfunctions PROBLEM POSSIBLE CAUSE SOLUTION • Device is switched off • Switch on the device • Power supply is interrupted • Check the power supply Device does not • Ambient temperature is • See that an ambient function. below 10°... -
Page 14: Waste Disposal
NOTE! For the disposal of the device please consider and act according to the national and local rules and regulations. Bartscher GmbH Franz-Kleine-Str. 28 D-33154 Salzkotten phone: +49 (0) 5258 971-0 Germany fax:...