Oki ES9455 MFP Quick Start Manual page 18

Chapter 1 PREPARATIONS
Saving power when not in use – power saving modes –
This equipment supports three power saving modes; the Automatic Power Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Power saving Procedure to switch
modes
When a specified period of
Automatic
time
Power Save
last use of the equipment.
mode
When the [POWER SAVE]
button
Sleep mode when a specified period of
time
last use of the equipment.
When the [POWER SAVE]
button
Super Sleep when a specified period of
mode time
the last use of the
equipment.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [POWER SAVE], [COPY], [Filing Box], [SCAN], [PRINT] and [FAX] buttons.
*3 [POWER SAVE] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).
*5 The Wireless LAN Module and/or OKI IC Card Reader.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO (-1000MB)] or [1000BASE FULL], the
equipment enters into the Sleep mode. For details, refer to the following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*7 Depending on the network environment of the user, the time for switching to the Super Sleep mode may take more than 10 minutes even though it
has been set to 10 minutes or less.
For changing the set period of time for entering into each mode, refer to the following guide:
For the European version
Contact your service representative to change the default settings noted above.
& MFP Management Guide (PDF): "Chapter 2: SETTING ITEMS (ADMIN)" - "Setting General Functions"
When the set period of time for switching to the Automatic Power Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
14
Conditions to enter into
modes
has passed since the
*1
When a particular option
is pressed or is installed or when a
*3
particular protocol
*4 has passed since the enabled.
When a particular option
is pressed or is not installed and also
*3
when a particular protocol
has passed since is disabled.
*4 *7 *6
Status of equipment
the mode
"Saving power - press
START button. " appears on
—
the touch panel.
The touch panel display
*5
goes off and the [POWER
is SAVE] button lights in
*6
green.
Only the MAIN POWER
*5
lamp (green) lights.
Conditions to recover
from the mode
When a button on the
control panel is pressed
*2
or when print data or fax
data are received.
Same as the Automatic
Power Save mode.
When the [POWER] button
is pressed, when print or
fax data are received
through a wired LAN or
when the time set for
Scheduled Print has come.