Table of Contents
Advertisement
Connection
When connecting a signal source to the projector, be sure to:
1.
Turn all equipment off before making any connections.
2.
Use the correct signal cables for each source.
3.
Ensure the cables are firmly inserted.
•
In the connections shown below, some cables may not be included with the projector (see
contents" on page
•
The connection illustrations below are for reference only. The rear connecting jacks available on the
projector vary with each projector model.
(VGA)
1.
VGA cable
2.
VGA to DVI-A cable
3.
USB cable
•
Many notebooks do not turn on their external video ports when connected to a projector. Usually a key
combo like FN + F3 or CRT/LCD key turns the external display on/off. Locate a function key labeled CRT/
LCD or a function key with a monitor symbol on the notebook. Press FN and the labeled function key
simultaneously. Refer to your notebook's documentation to find your notebook's key combination.
•
The D-Sub output only works when an appropriate D-Sub input is made to the COMPUTER-1 jack.
•
If you wish to use this connection method when the projector is in standby mode, make sure the
Monitor Out function is turned on in the SYSTEM SETUP: Advanced menu. See
on page 42
16
Connection
8). They are commercially available from electronics stores.
Monitor
Notebook or desktop computer
(DVI)
1
2
3
for details.
1
or
or
4.
HDMI cable
5.
Component Video to VGA (D-Sub)
adapter cable
A/V device
4
5
"Standby Settings"
"Shipping
Advertisement
Table of Contents
