Teac CR-H101DAB Reference Manual page 35

Playing back audio files from a computer
1
Connect this unit to the computer using a USB cable.
o To use a Windows computer, you must install the dedicated driver
beforehand (page 34).
o No driver is necessary when using a Mac computer.
o Use a USB cable with a connector that matches that of this unit.
2
Turn the computer on.
o Confirm that the computer has started up correctly.
3
Press the STANDBY/ON (¤) button to turn the unit
on.
4
Turn the SOURCE knob to select USB.
5
Start playback of an audio file on the computer.
If you can adjust the volume from the computer, set it to its maxi-
mum level and use this unit's VOLUME knob to adjust the level for
the best audio quality.
o If you are using the TEAC HR Audio Player Application, the vol-
ume cannot be adjusted from the computer.
Turn this unit's VOLUME knob to MIN before starting playback. Then,
gradually turn it up.
o The computer and this unit cannot control each other.
o Do not do any of the following when playing back an audio file via USB. Doing so could cause the computer to malfunc-
tion. Always quit the music playback software before doing any of the following.
i Disconnect the USB cable
o When playing back an audio file via USB, computer operation sounds will also be output. If you do not want these sounds
to be output, make appropriate settings on the computer to turn them off.
o If you connect this unit with the computer or you set the playback source to USB after starting music playback software,
music files might not play back properly. If this occurs, restart the music playback software or restart the computer.
i Put the unit into standby
USB cable
i Change the playback source
35