Advertisement
TIGHTEN!
FIGURE 2
STEP 2:
• Pull up the SPRING PIN on the LEG PRESS FRAME (2) and insert the BACK PAD ADJUST (46). Assemble one 5/16 X 1/2" SHOULDER
BOLT (47) to the BACK PAD ADJUST (46) as shown in FIGURE 2.
• Securely tighten all loose frame connections made to this point, then proceed to snap RH CAPS
(38) over the RH WASHERS (36) on all tightened connections.
FIGURE 3
STEP 3:
• SECURELY assemble the HANDLE (3) to the LEG PRESS FRAME (2) using four RH CAPS (38), two 3/8 X 67mm BOLTS (27), four 3/8"
SAE WASHERS (35), four 3/8" RH WASHERS (36) and two 3/8" LOW HEIGHT LOCK NUTS (34) as shown in FIGURE 3.
46
3/8 X 67mm 27
36
3
2
6
2
47
TIGHTEN!
38
35
34
Advertisement
