Advertisement
1
FIGURE 11
STEP 11:
• Route the WEIGHT STACK CABLE (13) around one 4-1/2" PULLEY (16) and SECURELY assemble the 4-1/2" PULLEY (16) to the
FLOATING PULLEY BRACKET (9) using two 3/8 X 43mm BOLTS (25), four RH CAPS (38), four 3/8" SAE WASHERS (35), four 3/8" RH
WASHERS (36), and two 3/8" LOW HEIGHT LOCK NUTS (34) as shown in FIGURE 11.
• SECURELY assemble the end of the WEIGHT STACK CABLE (13) between the flats on the TOWER (1) using one 3/8 X 43mm
BOLT (25), two RH CAPS (38), two 3/8" SAE WASHERS (35), two 3/8" RH WASHERS (36), two 5/8 X 3/8" SPACERS (45) and one
3/8" LOW HEIGHT LOCK NUT (34) as shown in FIGURE 11. (NOTE: Do not overtighten!)
34
36
35
45
13
16
25 3/8 X 43mm
9
25 3/8 X 43mm
12
38
Advertisement
