Changing The Battery; Troubleshooting - SAGEMCOM Seen User Manual

Seen – Seen A
G
ENERAL PRODUCT CARE
To keep your telephone working and looking good, follow these guidelines:
 Avoid putting the phone near heating appliances and devices that generate electrical noise (for
example, motors or fluorescent lamps).
 DO NOT expose to direct sunlight or moisture.
 Avoid dropping and other rough treatment to the phone.
 Clean with a soft cloth.
 Never use a strong cleaning agent or abrasive powder because this will damage the finish.
 Retain the original packaging in case you need to ship the phone at a later date.

Changing the battery

Make sure the telephone is OFF before you replace battery.
1. Remove the battery compartment door.
2. Remove old battery.
3. Insert the new battery.
4. Put the battery compartment door back on.
5. Place handset in the base to charge.
T
ROUBLESHOOTING
Causes of poor reception:
Aluminium siding.

Foil backing on insulation.

Heating ducts and other metal construction can shield radio signals.

You are too close to appliances such as microwaves, stoves, computers, etc.

Atmospheric conditions, such as strong storms.

Base installed in the basement or lower floor of the house.

Handset battery is low.

You are out of range of the base.


Troubleshooting

Problem

Make sure the battery is properly installed and connected.
No display

Place the handset on the charger and fully charge the battery (at least 15 hours).

Make sure the RINGER setting on the handset is programmed to ON.
Handset

You may have added too many handsets to your phone line. Try
does not ring
disconnecting some of your phones and try again.

Not possible Check that your handset is within range and move close to the base unit
to make a (approximately 50 meters indoors and up to 300 meters in open space).
call despite 
Check if the base unit is plugged into a wall socket that is shared with other
dial tone
household appliances. Unplug other device and try again.
Solution
22