Table of Contents
Advertisement
Seen – Seen A
Installing the phone
1.
Connect the power adapter cord to
the socket on the bottom of the
base.
2.
Connect the other end of the cable
with the power wall socket.
3.
Plug the phone cable into the socket
of your base.
4.
Connect the other end of the cable
with the phone wall socket.
5.
Insert the battery connector into the
respective socket complying with its
position.
6.
Slide the battery pack into its
housing.
7.
Fit the rear part of the handset to
the front part.
8.
Place the handset in the base
station to charge for 12 hours prior
to first use.
If your handset battery is empty leave the handset in the charging unit for at
IMPORTANT
least 4 minutes. You will then be able to switch it on again
2
1
3
4
5
6
8
6
7
Clack
Clack
12 H
Advertisement
Table of Contents
Need help?
Do you have a question about the Seen and is the answer not in the manual?
Questions and answers
The date and time will not change from 02-04-2016 and time is HR out and will not adjust in the handset settings for date and time
To fix the date and time issue on your SAGEMCOM Seen device:
1. Go to the menu "hs settings" → "Date & time".
To set the time:
2. Select "set time".
3. Enter the correct time in HH:MM (24-hour format).
4. Press the confirmation key.
To set the date:
5. Select "set date".
6. Enter the correct date in DD/MM/YY or MM/DD/YY format.
7. Press the confirmation key.
Use the navigation keys (labeled as 5 or 6) to correct mistakes if needed.
This answer is automatically generated
@Mr. Anderson I have done this repeatedly and it is not working