Table of Contents
Advertisement
Seen – Seen A
A
NSWERING MACHINE SETUP
Modify the answering machine mode
1.
Go to the menu
"ANS.
2.
Select "ANS & REC" or "Answer only" using the or key to activate or deactivate your
answering machine, press
Modifying the outgoing message (OGM)
Recording a personal outgoing message
1.
Go to the menu
"ANS.
2.
Select "RECORD Mess" using the or key, press
3.
Record your message.
4.
At the end of your message, press
A beep will confirm that your message is now being used.
If you make a mistake while recording the message, repeat the operations described above until
you are satisfied with your message.
The recording of a new message will automatically replace the previous
message
The maximum recording duration for a message is 180 seconds.
The recording start and end beeps are not part of your message
Listening to your answer machine message
1. Go to the menu
"ANS.
2. Select "playback" using the or key, press
3. Your current answer machine message will be played. Your handset will automatically return
to the previous menu.
If you have not saved a personal message, the answering machine will
automatically use the pre-recorded message.
Number of rings
This parameter enables you to set the number of times your telephone rings before the answering
machine answers a call. The number of rings can be set between 2 and 8.
You can also select the "time saver" mode. The "time saver" mode automatically determines the
number of rings: If there are no new messages on the answering machine, the number of rings
will be 4, otherwise the number of rings will be 2.
1. Go to the menu
"ANS. MACHINE
2. In the list, select the desired number of rings (between 2 and 8) using the or keyor the
" time saver " mode, press
Recording time of incoming messages
Define the maximum time a caller has to leave their message.
1. Go to the menu
"ANS. MACHINE
2. Choose the desired recording time (60 s, 120 s, 180 s or unlimited) by using keys or , then
press
.
(M
ODELS
MACHINE" "tam settings" "ANSWER MODE".
. A confirmation beep is issued.
MACHINE""tam settings" "Ogm settings" "ANS & REC" (or "ANSWER ONLY").
.
.
MACHINE""tam settings" "Ogm settings" "ANS & REC" (or "ANSWER ONLY").
""tam settings" "answer delay ".
.
""tam settings" "record time ".
S
A
)
EEN
ONLY
.
.
18
.
Advertisement
Table of Contents
Need help?
Do you have a question about the Seen and is the answer not in the manual?
Questions and answers
The date and time will not change from 02-04-2016 and time is HR out and will not adjust in the handset settings for date and time
To fix the date and time issue on your SAGEMCOM Seen device:
1. Go to the menu "hs settings" → "Date & time".
To set the time:
2. Select "set time".
3. Enter the correct time in HH:MM (24-hour format).
4. Press the confirmation key.
To set the date:
5. Select "set date".
6. Enter the correct date in DD/MM/YY or MM/DD/YY format.
7. Press the confirmation key.
Use the navigation keys (labeled as 5 or 6) to correct mistakes if needed.
This answer is automatically generated
@Mr. Anderson I have done this repeatedly and it is not working