Table of Contents
Advertisement
Using Foam-Type. Cleaner on Fabric
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
directions on the container label.
Mix
Multi-Purpose Powdered Cleaner following the
@
Use suds
only
and apply with a clean sponge.
@
Don't saturate the'material.
Don't rub it roughly.
As soon as you've cleaned the section, use a sponge
to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe off what's left with a slightly damp paper towel
of cloth.
Then dry
it
immediately with a blow dryer or a heat
lamp.
NOTICE:
Be careful. A blow dryer may scorch the fabric.
Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean off better with just
water and mild soap.
If you need to use a solvent:
Gently scxape excess soil from the trim material with
a clean, dull knife or scraper. Use very
little cleaner,
light pressure and clean cloths/(preferably
cheesecloth). Cleaning should start at the outside of
the stain, "feathering" toward the center. Keep
changing to a clean section of the cloth.
e
When you clean a stain from fabric, immediately dry
the area with a blow dryer to help prevent a cleanin
ring. (See the;previous NOTICE.)
6-49
Advertisement
Table of Contents
