Table of Contents
Advertisement
* .
4.
8. Put the new headlamp in position.
Make sure the socket points in the same
direction as it did with the old headlamp.
9. Insert the tabs on the
aiming
ring
into the slots
in
the headlamp
assembly.
10. Holding the aiming ring closed, insert the screws at
the end of the ring. Tighten the screws until the
aiming ring touches the plastic nuts on both the
top
and bottom.
0.
Do not overtighten.
Do not damage the vertical aiming bubble.
1
1
6-32
Advertisement
Table of Contents
