Table of Contents
Advertisement
17
Pairing Additional Cameras
NOTE
If you have purchased additional cameras, it is highly recommended to pair the cameras to the receiver
before permanent installation.
"Pairing" is an electronic handshake between wireless devices. Wireless devices and com-
ponents need to be paired in order to communicate with each other.
The camera(s) provided with the system have already been paired to the receiver. By de-
fault, the camera(s) included are automatically paired to channels 1 and 2 on the receiver.
See the channel label on the camera to check which channel it has been set to.
If you have purchased additional accessory cameras, you will need to pair them to the re-
ceiver. When pairing cameras, you can select the channel you would like the cameras to
be assigned to. You can also use the steps below to reassign your existing cameras to dif-
ferent channels.
NOTE
Accessory cameras are available from www.lorextechnology.com
To pair an additional camera:
1. Connect the new camera to a power outlet. Place the camera and the receiver within
1ft of each other.
2. Tap
, then go to General Settings > Camera Setup > Pairing.
3. Select the channel you wish to pair the camera to.
• If you pair a new camera to a channel that is already being used by an existing cam-
era, the new camera will be connected to that channel. The old camera will auto-
matically be disconnected.
4. Following the on-screen prompt, press the Pair button behind the camera. You have
30 seconds to press the Pair button on the camera. Once paired, the camera will be
immediately displayed on-screen.
NOTE
•
If you do not press the Pair button on the camera during the 30 second pairing window, repeat steps
2~4 to try the pairing process again.
•
If the speaker begins squealing, move the camera and receiver away from each other.
#LX400069; r.28523/28523; en-US
49
Hide quick links:
Advertisement
Table of Contents
