Decon wheel e-move User Manual page 12

Use of e-move
Activation of the system
1) Lock the wheelchair brakes.
2) Activate e-move by pressing the button (A) on the right side of the chair. A beep will then be
heard, and within three seconds the system will be activated.
If you apply force to the drive rings while simultaneously switching on the current, you will hear a
warning signal (long beep) and the wheelchair will not start. Switch the current off and on again
without touching the drive rings. Then wait until the system has been activated before applying
force to the drive rings.
3) Release the wheelchair brakes.
4) It is important that the user be aware of how the wheelchair works before starting to drive (study
the wheelchair manufacturer's safety instructions in the directions for use). To drive the wheelchair
straight ahead, push the wheels evenly.
A
Decon Wheel AB Tel + 46 (0) 345-408 80
Landerydsvägen Fax +46 (0) 345-408 95
314 22 Hyltebruk www.decon.se
Sweden info@decon.se