Table of Contents
Advertisement
It is recommended that the administrator decides which mode is better for a multiple-service-zone
deployment before proceeding further with the system configuration. Settings for the two VLAN modes
are slightly different, for example, the VLAN Tag setting is required for Tag-Based mode.
Select Service Zone Mode: Select a VLAN mode, either Port-Based or Tag-Based.
Caution:
The switches deployed under AMG-2100/AMG-2101 in Port-Based mode must be Layer2 Switches
only. The switch deployed under AMG-2100/AMG-2101 in Tag-Based mode must be a VLAN switch
only.
Port-Based: When Port-Based mode is selected; traffic from different virtual Service Zones will
be distinguished by physical LAN ports. Each LAN port can be mapped to one Service Zone in the
form of a many-to-one mapping between ports and Service Zones.
Specify a desired Service Zone for each LAN Port: For each LAN port, select a Service
o
Zone to which the LAN port is to be mapped from the drop-down list box.
By factory default, all LAN ports are mapped to Default Service Zone; therefore, the
administrator can enter the web management interface via any LAN port upon the first
power up of the system. From the drop-down list box, all disabled Service Zones are
gray-out; to activate any desired Service Zone, please configure the desired Service Zone
under the Service Zone tab and enable its Service Zone Status.
AMG-2100
Gigabit Access and AP Management Gateway/
AMG-2101
Gigabit Access and AP Management Gateway Plus
36
User's Manual
Advertisement
Table of Contents
