MakerBot Digitizer User Manual page 7

This safety alert symbol
indicates a potential safety hazard that could harm you or others or cause product or
property damage.
Important safety information is contained in this manual. Please read the following
messages thoroughly before using the MakerBot Digitizer™ Desktop 3D Scanner.
Warning:
If the MakerBot Digitizer gets wet, immediately disconnect it from power and
allow it to dry completely before attempting to use it again.
Caution:
Handle the MakerBot Digitizer with care; it includes sensitive electronic and
optical components that may be damaged if it is bumped or dropped.
Caution:
Avoid excessive humidity or temperatures. When the MakerBot Digitizer is in
use, avoid temperatures above 32° C or below 0° C. Do not store the MakerBot Digitizer
in areas where temperatures exceed 32° C or fall below 0° C.
To use the MakerBot Digitizer safely, adhere to the following guidelines:
• Do not touch the camera filter or camera lens; oil or smudges may decrease the
MakerBot Digitizer's performance.
• Do not touch the laser housing while the MakerBot Digitizer is powered on.
• Do not operate the MakerBot Digitizer if any part of the machine is cracked or
otherwise damaged.
• Only use the provided power supply with the MakerBot Digitizer.
• Do not use power or USB cables if damaged.
• Do not force USB or Power connector into place.
• The socket-outlet must be installed near the equipment and must be easily accessible.
SAFETY AND COMPLIANCE
precedes each safety message in this manual. This symbol
WELCOME, LET'S GET STARTED WELCOME, LET'S GET STARTED
7