MakerBot Digitizer User Manual page 29

UNPACKING YOUR MAKERBOT DIGITIZER (CONTINUED)
6 Connect the MakerBot Digitizer to a Computer
Locate the USB cable from the accessory
box and use it to connect the MakerBot
Digitizer to your computer.
7 Connect the Power Supply
Ensure that the power of the MakerBot
Digitizer's power switch is set to Off.
Locate the power supply and power cable
from the accessory box and attach the cable
to the power supply.
Insert the power supply connector into
the power input port on the back of the
MakerBot Digitizer and plug the power cord
into an electrical outlet.
Caution:
The socket-outlet must be installed near the
equipment and must be easily accessible.
Note: MakerBot's distributor will provide a certified plug adapter with national pin
i
configuration for international users.
SETTING UP YOUR MAKERBOT DIGITIZER
29