Makerbot Digitizer Placement - MakerBot Digitizer User Manual

PLACEMENT OF THE MAKERBOT DIGITIZER
Finding the right location for your MakerBot Digitizer is important.
Follow these guidelines to ensure the best quality scans:
• Set up your MakerBot Digitizer in an indoor area with ample incandescent
or fluorescent light. Avoid natural light sources.
• Avoid pointing the MakerBot Digitizer's camera and lasers toward light sources.
Avoid placing the MakerBot Digitizer directly below a light source.
• Place your MakerBot Digitizer on a flat, stable work surface and make sure no part of
the MakerBot Digitizer extends over the surface edge. If it is not in a stable position,
the MakerBot Digitizer could fall, damaging itself and causing injury to the user.
• Make sure to set up your Makerbot Digitizer at least one foot away from the nearest wall.
AERIAL VIEW OF ROOM
28
Light sources
should be placed
outside of the
MakerBot Digitizer's
line of sight.
Avoid natural light
aiming directly at camera.
Set up at least 1 ft
away from a wall.
MAKERBOT DIGITIZER