Technical Data - Hilti TE 30-A36 Operating Instructions Manual

1 Side handle with depth gauge
1 Operating instructions
NOTE
Accessories can be found at your Hilti Center or online at www.hilti.com.
3.4 Additional items required for operating the tool
A suitable battery of the specified type (see table in the Technical Data section) and a suitable battery charger from
the C 4⁄36 series. For further information about battery charging, please read the operating instructions for the battery
charger.
3.5 Lithium‑ion battery charge status
The Li-ion battery features a charge status display. The charge status is indicated by the LEDs on the battery during
charging (please refer to the operating instructions for the charger). When the battery is not in use, pressing one of the
battery release buttons or inserting the battery into the power tool causes the battery charge status to be displayed
by the four LEDs for three seconds.
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs flash, please refer to the information given in the Troubleshooting section.

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load, n₀
Single impact energy in accordance with EPTA proced-
ure 05/2009
Hammer drilling in concrete
Percussion core bit in concrete/masonry
Drilling diameter in steel
Drilling diameter in wood
Battery
Rated voltage
Capacity
Energy capacity
Weight
Type of cell
LEDs blink
-
-
-
-
LED 1
TE 30‑A36
36 V
5.5 kg
853/min
3.6 J
10...20 mm
25...68 mm
5...10 mm
5...15 mm
B 36/6.0 Li‑Ion
36 V
6 Ah
216 Wh
1.8 kg
Li‑ion
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
en
15