Lacanche CLUNY INDUCTION Manual page 24

Never place or leave enamelled, aluminium or any other type of empty pan on a heating zone.
Similarly you should not place aluminium-packed products/ tin fail directly on the surface; this can do
irreparable damage to your cooker.
Do not place unopened tins directly on a hotplate as this could cause them to explode under
pressure.
Never obstruct ventilation zones (front panel, rear ventilation, etc.). The cooker may overheat and
become less efficient. Furthermore you shorten the service life of your hob.
Do not store aerosols or flammable products under the cooking surface.
Use a magnet to check that your pans are ferromagnetic. If they stick to the magnet, you can use
them on induction hotplates.
Do not hang heavy items over the cooking surface. They can damage the vitro-ceramic surface if
they fall.
Never apply more heat than can be absorbed by the food: too much heat causes loss of water,
grease and wastes energy.
Whenever the recipe permits, cover your cookware with a lid in order to save energy.
Safety
:
The latest scientific research has found that people fitted with a heart pacemaker are not at risk from
using induction cookers. However, if an induction cooker is used improperly a slight risk cannot be
ruled out.
It is for this reason that we advise people with pacemakers to consult their physician before using an
induction cooker.
Avoid all contact between jewellery (rings, chains, etc. ) and the cooking surface while it is switched
on; it could cause jewellery to heat.
CAUTION
:
If a visible crack appears in the vitro-ceramic surface of your hob, immediately disconnect
the power supply and contact your installer.
Display :
The sensor for a particular hotplate is not
F
working
H Residual temperature
Pan undetected
U Temperature hold : 70 °C
u Temperature hold : 42 °C
L Child safety function
P Booster function
Fault detected in the induction system
If the induction cooker does not work
• Check your pans
• First switch off the cooker. Then check ventilation of the generator
• First switch off the cooker. Then check the power supply and electrical connectors.
USER'S MANUAL
INDUCTION HOB
The rest of the surface can nevertheless continue functioning
correctly
– Contact your retailer
Indicates that the zone is hot
– The display goes out when the temp has dropped below 60°C
No pan or pans unsuitable for induction cooking
-
-
This function is activated and deactivated by holding the knob in
position "A"
This function is only available on hotplates A and B. .
This function is activated and deactivated by holding the knob in
position «A».
Check the control encoder connectors.
Check the connection to the encoders and inductors and for any
damaged or cut wires
Cluny induction - Ft 151a - GB - Rév 05 - Modifié le : 07/10/2013 24/31