Troubleshooting - ARIETE Konsuelo Plus User Manual

TROUBLESHOOTING

If there are problems with operation, immediately turn off the machine and unplug it from the socket-outlet.
PROBLEM cause
The coffee maker Air has probably entered the
does not supply circuit and deactivated the pump.
boiling water for
tisanes.
The steam exit hole on the
dispenser wand is clogged.
The coffee maker There is little water and the pump
does not supply
does not suck it up.
steam.
The steam exit hole on the
dispenser wand is clogged.
Coffee overflowing Residues of ground coffee have
from the edges of
remained on the gasket of the
the filter ring. filter holder coupling seat.
Faulty pod.
the coffee is not The holes of the filter holder cou-
supplied or flows
pling seat are clogged
too slowly.
The tanks is not inserted well.
There is little water and the pump
does not suck it up.
Faulty pod.
Broken pod.
8
solutions
Make sure the tank is properly inserted and that the water is
not below the minimum level. Repeat the operations described
in the "Preliminary phases for use" paragraph.
Unclog any deposits that may have formed in the hole of the
dispenser wand with a pin.
Check that the water level in the tank is correct. If necessary,
fill it with cool tap water
Unclog any deposits that may have formed in the hole of the
dispenser wand with a pin.
Coffee overflowing from the edges of the filter ring.
Clean the seal with a toothpick or a sponge (Fig. 19).
Slowly remove and disconnect the filter holder because any
remaining pressure could cause splashes or squirts. Clean the
coupling seat with a sponge (Fig. 19). Replace the pod in the
filter holder.
Turn on the machine without the filter holder, making the water
run. Perform decalcification following the instructions provided
with the product.
Fit the tank securely by pushing it as far as it will go.
Check that the water level in the tank is correct. If necessary,
fill it with cool tap water.
Slowly remove and disconnect the filter holder because any
remaining pressure could cause splashes or squirts. Clean the
coupling seat with a sponge (Fig. 19). Replace the pod in the
filter holder.
Slowly remove and disconnect the filter holder because any
remaining pressure could cause splashes or squirts. Clean the
coupling seat with a sponge (Fig. 19). Replace the pod in the
filter holder.