Table of Contents
Advertisement
Identification data
The following machine identification data are shown on the plate found underneath the machine's standing base:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
PRELIMINARy PHASES FOR USE
Starting the appliance
Check that the voltage of the domestic network is the same as that indicated on the technical information plate of the appli-
ance. Place the appliance on a flat surface.
Before using the appliance for the first time wash the tank. Fill it up with fresh cool water and insert it in its housing (Fig.
4). Insert the plug into the socket, which must be earthed.
Starting the first time
After having filled the tank with cool tap water, start the machine by pressing the button (N). Indicator lamps (O) turn on to
indicate that the machine is on and that the internal boiler has started to heat up. The machine will be ready for the coffee
when the indicator lamp (Q) turns on. Press the coffee dispensing switch (P) until you see water come out of the filter holder
seat (Fig. 6).
If you are starting the machine for the first time or after a period of time during which it has not been used, it is
recommended that at least one cup of water be allowed to pass through the boiler's hydraulic circuit. Also open the
steam tap (J) by slightly turning it anti-clockwise after having placed a container underneath the Maxi Cappuccino
device wand (L) Fig. 7.
Then close the steam tap (J) by turning it clockwise, and press the coffee dispensing switch (P) to make the water stop
coming out.
HOW TO MAKE COFFEE
Put the drip tray (C) and pod filter (B) inside the filter holder (D).
Place the pod in the filter ring (Fig. 8).
Push the pod towards the bottom of the filter with your fingers (Fig. 9). The pod must be well centred and placed inside
the filter.
Now it is possible to put the filter holder in its seat.
Warning!
Tighten well by turning it from left to right while making sure you have hooked it properly onto the flange (Fig. 11).
f the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water could leak from the
filter holder.
It is a good idea to start dispensing the coffee only when the indicator lamp (Q) is on, and this is true for both the first cup
and those that follow.
To start dispensing, press the switch (P): the coffee will start coming out of the spouts of the filter holder. Press the switch
(P) again to stop it.
The maximum serving of coffee is 50 ml.
Warning!
Like in professional coffee machines, do not remove the filter holder when the dispensing switch (O) is on; danger
of burns!
Warning!
Wait about ten seconds after the coffee has been dispensed before removing the filter holder. To remove it, turn it
slowly from right to left so as to prevent splashes or spurts of water or coffee.
The pod could remain stuck in the upper part of the machine after making the coffee and when removing filter
holder. To remove it, tilt the filter holder (Fig. 14) so the pod can fall onto it.
When the machine is in stand-by, the lamp (Q) will turn on and off periodically. This shows that the boiler thermostat is trip-
5
Advertisement
Table of Contents
