Changing The Display Settings; Power Management Options In Windows Xp; Standby Mode - Dell Vostro 200 Owner's Manual

3 Connect the other end of the S-video cable to the S-video input connector
on your TV.
4 Connect the VGA or DVI monitor.

Changing the Display Settings

1 After you connect the monitor(s) or TV, turn on the computer.
The Microsoft
2 Enable clone mode or extended desktop mode in the display settings.
• In clone mode, both monitors display the same image.
• In extended desktop mode, you can drag objects from one screen to
the other, effectively doubling the amount of viewable work space.
For information on changing the display settings for your graphics card, go to
.
support.dell.com

Power Management Options in Windows XP

The Microsoft Windows XP power management features can reduce the
amount of electricity your computer uses when it is on and you are not using
it. You can reduce power to just the monitor or the hard drive, or you can use
standby mode or hibernate mode to reduce power to the entire computer.
When the computer exits from a power conservation mode, it returns to the
operating state it was in prior to entering the mode.
NOTE:
Windows XP Professional includes security and networking features not
available in Windows XP Home Edition. When a Windows XP Professional
computer is connected to a network, different options related to security and
networking appear in certain windows.
NOTE:
The procedures to activate the standby and hibernate modes may vary
according to your operating system.

Standby Mode

Standby mode conserves power by turning off the display and the hard drive
after a designated period of time, known as a time-out. When the computer
exits from standby mode, it returns to the operating state it was in prior to
entering standby mode.
NOTICE:
If your computer loses power while in standby mode, it may lose data.
® ®
Windows desktop displays on the primary monitor.
Setting Up and Using Your Computer
33