Dell Vostro 200 Owner's Manual page 118

2
1
1 alignment bar
4 bracket within
slot
8 Replace the support bracket (see "Replacing the Support Bracket" on
page 161) and then press down the card retention bracket to seat it on its
slot.
9 Ensure that:
• The guide clamp is aligned with the guide notch.
• The tops of all cards and filler brackets are flush with the alignment
bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
10 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable
connections.
118
Removing and Installing Parts
3
2 fully-seated card
5 bracket caught
outside of slot
6
3 not fully-seated card
6 alignment guide
4
5