Dell Vostro 200 Owner's Manual page 138

10 If you are not reinstalling the Media Card Reader, replace the drive panel
insert, as needed.
11 Replace the optical drive (see "Installing an Optical Drive" on page 141).
12 Replace the bezel (see "Replacing the Bezel" on page 123).
13 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
14 Connect your computer and devices to electrical outlets, and then turn
them on.
Installing a Media Card Reader
1 Follow the procedures in "Before You Begin" on page 99.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3 Remove the bezel (see "Removing the Bezel" on page 122).
4 If this is a new card reader installation:
• Remove the drive panel insert (see "Removing the FlexBay Drive Panel
Insert" on page 135).
• Remove the Media Card Reader from its packaging.
5 Remove the optical drive (see "Removing an Optical Drive" on page 140).
6 Remove the FlexBay drive panel insert (see "Removing the FlexBay Drive
Panel Insert" on page 135).
7 Press the two spring clamps and slide out the FlexBay drive cage from the
front of the system (see "Removing a Floppy Drive" on page 131).
8 Place the Media Card Reader in the FlexBay drive cage and slide the
Media Card Reader in to align the screw holes in the Media Card Reader
with the cage notch.
9 Tighten the two screws to secure the floppy drive in the FlexBay drive
cage.
10 Slide the FlexBay drive cage along with the floppy drive into the FlexBay
slot till it snaps in place.
11 Connect the FlexBay USB cable to the back of the Media Card Reader and
to the internal USB connector on the system board (see "System Board
Components" on page 105).
138
Removing and Installing Parts