R.V.R. Electronica TEX30LCD User Manual page 17

ELETTRONICA
5.2.4 Controllo del livello di potenza di uscita
Note: The exciter incorporates Automatic Gain Control (AGC) and output power is
modulated based on the power level set by the user and actual operating conditions,
such as temperature, reflected power and other parameters. Please read section
5.3 for more details of RF power modulation.
Access the Power Setup Menu pressing the following keys in the order:
ESC (opens Default Menu) ⇒ ENTER (hold down for 2 seconds)
Use the keys
at the side of SET provides a graphic indication of power setting; please consider
that the forward power readout provided on the display (FWD: xxxx W) reflects
actual output power reading, which may be lower than regulated power supply
when Automatic Gain Control is running in power supply limitation mode
(please read section 5.3 about RF power supply modulation for more details).
Note: Output power may be set using the Pwr OFF control. In this condition, the
output power readout (Fwd) on the display will read 0 (zero); the SET bar will reflect
any adjustments you make using the keys and provides a graphic indication of how
much power supply will be delivered the moment you return to Pwr On state.
5.2.5 Changing the Power Good alarm threshold
Change Forward Power Good alarm setting PgD from the Fnc menu as desired
(factory setting is 50%).
5.2.6 Setting equipment I
Change the IIC address in the MIX (Miscellaneous) menu as desired (factory
setting is 01).
5.2.7 Adjustments and calibration
The only manual adjustments are the level adjustments and the audio mode
adjustment.
The rear panel holds the trimmers for all exciter inputs. Trimmer identification is
printed on the rear panel. Input sensitivity can be set within the limits set out in
the tables below through the trimmers:
User Manual
and in the SET menu to set exciter output power; the setting bar
C address
2
Rev. 1.0 - 29/11/12
TEX30/50/100/150/300LCD
13
/ 32