R.V.R. Electronica TEX30LCD User Manual page 15

ELETTRONICA
√ For operating tests only: dummy load with 50 Ohm impedance and adequate
capacity (30W for TEX30LCD, 50W for TEX50LCD, 100W for TEX100LCD,
150W for TEX150LCD or 300W for TEX300LCD as a minimum).
√ Connection cable kit including:
• Mains power cable
• Coaxial cable with BNC connectors for interlock signal connection
• RF cable for output to load / antenna (50 Ohm coaxial cable with N-type
connector)
• Audio cables between transmitter and audio sources.
5.1.2 Connections
Connect the RF output of the transmitter to the antenna cable or a dummy load
capable of dissipating amplifier output power. To begin with, set exciter to minimum
output power and switch it off.
Connect the transmitter INTERLOCK IN input to the matching INTERLOCK OUT
output fitted on R.V.R. Elettronica equipment to act as hybrid couplers. If your
equipment is a different brand, identify an equivalent output.
WARNING: Electric shock hazard! Never handle the RF output connector
when the equipment is powered on and no load is connected. Injury or death
may result.
Ensure that the POWER switch on the front panel of TEX30/50/100/150/300LCD
is set to "OFF".
User Manual
TEX30/50/100/150/300LCD
Figure 5.2: connections with amplifier
Rev. 1.0 - 29/11/12
11
/ 32