Solid-State Drive (M.2) - HP ENVY x360 m6 Convertible Maintenance And Service Manual

Solid-state drive (M.2)

Description
256 GB solid-state drive (SSD), M.2, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the top cover (see
5. Disconnect the battery.
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Top cover on page 26).
Spare part number
813081-001
Component replacement procedures 31