Custom Door Panel - Sub-Zero UC-24BG Installation Manual

PANEL INSTALLATION

Custom Door Panel

For overlay applications, a custom door panel must be
installed. Panel size is critical for a proper fit. To verify panel
requirements and dimensions, refer to the Sub-Zero design
guide at subzero.com/specs.
Finish all sides of custom panels. They may be visible
when the door is open or through the window of glass door
models.
MODELS UC-24R AND UC-24C(I)
Remove the two panel mounting brackets attached to the
front of the door. Place the custom overlay door panel face
down on a protected work surface. Position the plastic tem-
plate provided, flush with the lower edge of the panel. Verify
proper location for right-hand (RH) or left-hand (LH) door
swing. Mark the holes, remove template and drill pilot holes
for the brackets. Secure mounting brackets with screws
provided.
If the template is not available, position mounting brackets
as indicated in the illustration below.
5
21 / "
8 (549)
7
/ "
8
(22)
RH DOOR SWING
1
15 / "
16
(382)
5 1
3 / " 3 / "
8 2
(92) (89)
23 3 / "
4 (603)
Panel mounting brackets.
1
30 / " LH DOOR SWING
16
(764)
To install the custom door panel, partially insert a screw in
the center of each mounting position on the hinge side of
the door. Engage the tabbed bracket to the handle side
of the door, then slide the hinge side mounting bracket onto
positioning screws. Slotted holes on the mounting bracket
should slide under screw heads to support the panel. Refer
to the illustration below. Panel can be adjusted
and down and side to side.
Once the custom panel is in place and properly adjusted,
attach remaining screws to the hinge side mounting bracket,
and install magnetic decorative caps as shown in the illus-
tration below.
DOOR
PANEL
BRACKET
SCREW
CAP
Panel installation.
1 / " up
(6)
4
|
subzero.com 9