Undercounter Refrigeration ..... 3 To ensure the safe and efficient installation of Sub-Zero equipment, please take note of the following types of Undercounter Specifications .
Any questions or problems regarding the installation should be directed to your authorized Sub-Zero dealer or Location of rating plate. Sub-Zero customer service at 800-222-7820. You may also check the contact &...
" hex bolt nut driver • Drill and assorted drill bits • 4' (1.2 m) of " copper tubing and saddle valve (4200880) for the water line (model UC-24CI) • Copper tubing cutter (model UC-24CI) • Masonite, plywood, " pressed fiberboard, cardboard...
Page 6
The electrical supply should be located within the shaded MODEL UC-24CI area shown in the illustration below. Follow the National For model UC-24CI, the water supply line for the ice Electrical Code and local codes and ordinances when maker should be located within the shaded area shown in installing the receptacle.
Undercounter Installation subzero.com/specs Unpack the Unit Anti-Tip Bracket Before moving the undercounter unit into position, make sure all opening dimensions, electrical and plumbing To prevent the unit from tipping forward and provide a requirements are complete and accurate. stable installation, the unit must be secured in place IMPORTANT NOTE: The floor under the undercounter unit with the anti-tip bracket.
Page 8
WATER LINE CONNECTION (MODEL UC-24CI) on its back or side, you must allow the unit to stand upright For model UC-24CI, connect the plastic tubing from the for a minimum of 24 hours before connecting power. ice maker to the household water line with the fitting con- With the undercounter unit near the installation opening, nection kit, provided.
Page 9
" (16) panel specifications. You can match your handle hardware with surrounding cabinetry or use a Sub-Zero accessory handle. Handles OUTDOOR MODEL UC-24RO must be attached directly to the overlay panel. Model UC-24RO is shipped from the factory with the...
Page 10
Undercounter Installation Overlay Panel Installation MODELS UC-24R AND UC-24C(I) Before attaching the overlay panel to the door, insert two screws, one in the center of each mounting position, just Inspect the overlay door panel for minimum thickness and far enough that the slotted holes on the hinge side door weight limit.
Page 11
This is to accommodate the rear surface of the panel. If the door panel is made of Sub-Zero accessory handles and provide for easy attach- such a material that pre-drilling is needed, all of the ment of the handle through the door frame.
Page 12
Undercounter Installation Overlay Panel Installation Hinge Adjustment IMPORTANT NOTE: The undercounter unit should be properly leveled before door hinge adjustments are made. The model UC-24BG glass door is made with a sealed, The top and bottom cabinet hinges are held in place with double-wall tempered glass core.
Page 13
Is the unit level? Are all leveling legs making contact with the floor? Is the kickplate installed properly? Is the water supply connected (model UC-24CI)? Have you checked for leaks? Is the door panel attached securely and properly aligned?
If you are storing or disposing of your old refrigerator service. or freezer, please do it safely. Remove the For the name and number of Sub-Zero factory certified doors or tightly secure service nearest you, check the contact & support section the doors closed.
Need help?
Do you have a question about the UC-24CI and is the answer not in the manual?
Questions and answers