2
Press CALIBRATION once to trigger calibration.
•
Press CALIBRATION three times to
trigger calibration if you re-locate the
portable left and right speakers and skip
Step 1 (calibrate the listening zone) after
you completed a round of spatial calibration
previously.
» You can hear the calibration tones from the
portable speakers.
3
Wait until the calibration tones end.
» If the calibration succeeds, DONE (done) is
displayed on the display panel. And the new
settings are stored.
Note
•
Spatial calibration takes around three minutes.
•
Surround sound improvement is only noticeable if
the portable left and right speakers (surround) were
improperly placed, or if there is strong surround effect
in the music you play.
•
If the portable left and right speakers are swapped in
placement, during calibration L<->R is displayed for few
seconds, then the calibration completes.
•
During calibration, you may press CALIBRATION
to cancel calibration, and the settings returns to the
default.
•
If the spatial calibration fails, an error message is
displayed on the display panel, such as FAIL (fail), and
the settings returns to the default.
•
If the spatial calibration fails, try the spatial calibration
again, and make sure that the calibration points
described at the beginning of this chapter are fully met.
EN
10
5
Use your SoundBar
This section helps you use the SoundBar to play audio
from connected devices.
Before you start
•
Make the necessary connections described in
the quick start guide and the user manual.
•
Switch the SoundBar to the correct source for
other devices.
Adjust the volume
1
Press +/- (Volume) to increase or decrease a
volume level.
•
To mute sound, press
•
To restore the sound, press
press +/- (Volume).
For the portable left and right speakers only
1
When the portable left and right speakers
are wirelessly connected to the main unit (in
SURROUND ON DEMAND mode), press
REAR VOL.+/- to increase or decrease a volume
level.
Choose your sound
This section helps you choose the ideal sound for
your video or music.
Surround sound mode
Experience an immersive audio experience with
surround sound modes.
•
Press MOVIE to create a surround listening
experience. Ideal for watching movie.
•
Press MUSIC to create stereo sound. Ideal for
listening to music.
Voice clarity
It makes human voice more clear and outstanding for
listening.
1
Press VOICE to switch to voice clarity.
» When voice clarity is turned on, VOICE is
displayed.
2
To exit this sound mode, press MOVIE or
MUSIC to select other sound mode.
.
again or