Water Connections - Releasing - Miele CVA610 Technical Information

Technical Information
If the steps 1-5 do not disclose any leaks - continue as follows.
6. Fill the Water Tank
7. Place the appliance into the Service Mode
8. Quickly turn the selector knob to the "Operation" position
9. Press and hold all three coffee buttons for 30 seconds
10. Quickly turn the selector knob to the "Programming" position
11. Press and hold all three coffee buttons - check for signs of leakage
(dripping, squirting etc...)
12. Release the three coffee buttons to end the test
5.48 Water Connections – Releasing
Danger - Risk of burning or scalding!
Components may be hot.
Pressurized Steam could exist in the system.
Before any service work is performed, allow time to cool.
Refer to Figure 5-47 below
1. Remove the retaining spring (Item 1).
2. Pull out the hose from the connector.
Remove the sealing rings (Item 2).
3.
1
2
3
Figure 5-47: Water system connections with clip
Retaining spring
Sealing rings
Pressed-on ring
86
CVA610 Coffee System