Mechanical Installation Guide For Suspended Ceilings; Mechanical Installation Guide For Sheet-Rock Ceilings - Tannoy CMS 801 DC BM Installation Manual

5.1 MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS

Remove the ceiling tile from its frame and place it on a flat surface. Mark the
1
cut-out area on the ceiling tile by tracing around the template provided.
2
Cut out the hole in the ceiling tile using a circular saw or pad saw.
Place the C-ring and tile-bridge on top of the ceiling panel, aligning the C-ring over the
3
hole, and screw the C-ring to the tile bridge using the fixings provided.
Slide the speaker assembly through the hole and turn the screws on the front of the
4
speaker to extend the mounting wings. Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5Nm.
DO NOT OVERTIGHTEN!
Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over
5
the railings, supporting the weight of the speaker.
Go to section 6 for instructions on wiring and set-up instructions.
6
5.2 MECHANICAL INSTALLATION GUIDE FOR SHEET-ROCK (PLASTER BOARD) CEILINGS
1
Mark the cut-out area on the ceiling by tracing around the template provided.
Cut out the hole in the ceiling using a circular saw or pad saw, then slide the
2
C-ring into the ceiling, aligning it over the cut-out hole).
3
Go to section 6 for wiring and set-up instructions then return to point 4 below.
4 Slide the speaker assembly through the hole and turn the screws to extend the mounting
wings. Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5Nm.
DO NOT OVERTIGHTEN!
5
Insert grille by pushing it onto the speaker.
7