Start-Up And Initial Ip Camera Configuration; Description Of Connectors And Control Tools; Zoom And Focus Adjustment - Novus NVIP-4DN3060H/IR-1P User Manual

NVIP-4DN3060H/IR-1P, NVIP-4DN3061H/IR-1P - User's manual (short form) ver 1.0.
START-UP AND INITIAL CAMERA CONFIGURATION
2. START-UP AND INITIAL CAMERA CONFIGURATION
1.4. Package contents
After you open the package make sure that the following elements are inside:

2.1 Description of connectors and control tools


IP camera

230 VAC / 12 VDC power supply

Accessories bag

Short version of user's manual

1. BNC video output CD containing manual and software
2. Audio input (MIC)
3. Power supply 12VDC
4. 100 Mb/s Ethernet port (RJ-45 hermetic connector)

2.2 Zoom and focus adjustment

If any of this elements has been damaged during transport, pack all the elements back into the original
Camera NVIP-4DN3061H/IR-1P
box and contact your supplier for further assistance.
1. Remover sunshield and front housing.
CAUTION!
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
Front housing
may cause short-circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
2. Adjust zoom and focus.
Focus
3. Mount front housing and sunshield.
Zoom
All rights reserved © AAT Holding S.A.
8
1
2
3
Sunshield
4