Starting The Ip Camera - Novus NVIP-4DN3060H/IR-1P User Manual

NVIP-4DN3060H/IR-1P, NVIP-4DN3061H/IR-1P - User's manual (short form) ver 1.0.

2.5. Starting the IP camera

To run NOVUS IP camera you have to connect ethernet cable between camera and network switch.
To power it up you can connect it directly via power supply adapter with parameters compatible with
camera power supply specification, or camera can be powered with PoE (IEEE 802.3af ) compatible
switch.
After connecting power supply it takes about 30 seconds to start camera. Then You can proceed to
connect to the camera via web browser.
The recommended way to start an IP camera and perform its configuration is a connection directly
to the network switch which is not connected to other devices. To obtain further information about
network configuration parameters (IP address, gateway, network mask, etc.) please contact your
network administrator.

Connection utilising network switch with PoE support
IP Camera
Power supply and
network transmission

Connection utilising external power supply and network switch
IP Camera
Network transmission
START-UP AND INITIAL CAMERA CONFIGURATION
Network Switch
PoE
Network transmission
Network Switch
Network transmission
All rights reserved © AAT Holding S.A.
11
Computer
Computer