1-14 Chapter 1: Product Overview
Cash Drawer Support
The 7402 Terminal can control a cash drawer through a cash drawer
Kickout connector on the back of the terminal (daughter card), or
through the cash drawer Kickout connector on the transaction printer.
The terminal can be configured with 0, 1, or 2 cash drawers. The first
drawer is attached to the terminal through a cable with an RJ‐45
connector. A second drawer can be connected using a 'Y' cable.
Note: A single Open/Close status signal is shared with both drawers.
Therefore, it is not possible to determine which cash drawer is open.
Power LED
The Processor Board provides support for an external green power
LED through the onboard Front Panel. This LED reflects the state of the
system power supply. The LED is turned on anytime the power supply
is fully on, which occurs when the system is on or in standby. The
power LED cannot be controlled by software. When the system is in
standby or in a screen saver, the power LED notifies the user that the
system is powered on and can quickly return to a normal working
state.
MSR
The MSR interface supports a maximum of 3 tracks of magnetic stripe
information for support of ISO format cards. Activate the MSR
interface by enabling it in BIOS Setup under IO Configuration. The
MSR interface controller is a memory‐mapped device, which can reside
at system memory addresses CA000, CC000, or D0000. If MSR
capability is not desired, it may be disabled through BIOS Setup.