Radio Connections; Radio Installation - REI CD-2000 Installation & Operation Manual

RADIO CONNECTIONS

Follow this easy wiring diagram when installing. Be sure to disconnect the battery
negative terminal before beginning.
8
REQUIRED RADIO DIMENSIONS
Verify the radio will fit by following the suggested dimensions below.

RADIO INSTALLATION

1. Verify lock Clips on the DIN collar are pressed inward. Place the collar into
the dash opening. Bend the locking tabs outward as shown on the drawing below to
secure into place in the Dash Opening.
2. Route all cable through the DIN collar and make all the necessary rear
connections with the radio. Verify clearance; then gently insert the radio into the DIN
Collar until both sides are locked. Install Trim Ring if not already installed. Secure
rear mounting stud for additional support if desired.
9