REI CD-2000 Installation & Operation Manual page 5

USB INTERFACE
USB Standard
Maximum Supply Current
File System
Decoding Format
SD CARD INTERFACE
Frequency Response (+/- 1dB)
Dynamic Range
Harmonic Distortion
Decoding Format
AUDIO PRE-AMP SPECIFICATIONS
Max Output level
Output Impedance
AUXILIARY INPUT SPECIFICATION
Frequency Response (+/- 1db)
Input Voltage Maximum Voltage
Input impedance
USB1.1/2.0 (Full Speed)
500mA
Fat16/32
same as CD
10 – 20,000Hz
80dB (1kHz)
0.01%
same as CD
2V
600Ω
20HZ – 20Khz
1200mV
10KΩ
12
9) TUNE / SEEK /TRACK Buttons
Under Radio mode, press the desired button to manually tune a station moving upward
or downward. Press and hold button momentarily and the radio will automatically seek
or down to the next available radio station. Press and hold button for 3 seconds and the
radio continuously tunes up or down until the button is released.
When playing digital media, use these buttons to track UP/DOWN to the desired
chapter to playback.
10) Auxiliary Input Jacks
The unit is equipped with a front panel 3.5mm auxiliary input so you can connect your
external portable audio player or portable satellite radio receiver. Press Mode to
display AUX 1 for operation. The radio is also equipped with a second Rear RCA
AUX 2 input. Press mode to display AUX 2 for operation.
*It may be necessary to adjust the volume level of your portable devise to achieve an
optimal volume level.
11) SD Card Input
Insert the SD card and the radio will automatically switch to the CARD input and
begin playback.
12) Display Button
Press this button to change display between available source information.
13) Clock Button
Press CLK button to change display between clock and source information.
Setting the Time:
With radio POWER ON, press CLK button momentarily to display the time. Next,
press and hold the CLK button until the hour display begins to flash. Rotate
Volume/Select Knob to adjust the hour. Press the CLK button again, and the minute
display will flash. Rotate Volume/Select Knob to adjust the minute. Press
Volume/Select to save the desired time.
14) USB Input
Insert a USB drive and the radio will automatically switch to USB input and begin
playback.
**Note: The unit's USB port does not support the Apple iPod or iPhone.
15) Eject Button
Press this button to eject CD disc.
5