Section 6 − Maintenance And Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller Electric Invision 456MP Owner's Manual

SECTION 6 − MAINTENANCE AND TROUBLESHOOTING

6-1. Routine Maintenance

3 Months
Replace
damaged or
unreadable
label.
Repair or
replace cracked
cables and cords.
Clean and
tighten weld
terminals.

6-2. Blowing Out Inside of Unit

!
Disconnect power
before maintaining.
Repair or
replace
cracked
cables.
6 Months
Blow out
inside.
.
Maintain more often
during severe conditions.
Replace
cracked
torch body.
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
802 314
OM-193 267 Page 35